For music enthusiasts, there is an urgent need for a music studio desk that can be raised and lowered! A combination of sitting and standing can alleviate the soreness caused by long-term sitting and enable yourself to enjoy music better. Let's take a look at how to build the liftable music table in $400!

You can watch the whole video on YTB：https://www.youtube.com/watch?v=kX51sgfdiY4&t=11s

Materials List:

FlexiSpot desk frame E7

（Link：https://www.flexispot.com/electric-height-adjustable-standing-desk-dual-motor-economical-option-ec3-ec4-1）

Electric circular saw

Ruler 

Band saw

Oblique hole punch

Electric drill

Vise

Oblique hole screw bit

screw driver bit

Woodworking hole opener

Angle Grinder

File

Black spray paint

Sandpaper

Wood wax oil

2 tracks

Support screw 78.7inch (2m)

Screw Nut

Gasket

Process: 

 

Part 1: Cutting wood

1.将整块木板用电圆锯锯成尺寸为：55*26 inch（140*66cm）的桌板；

1. Saw the whole board with an electric circular saw into a table with a size of 55*26 inch (140*66cm)

2. Cut a piece of board used to support things① with a size of 55*7.8 inch (140*20cm)

 

3. Cut a piece of board used to put the piano② with a size of 42*15.7 inch (106*40cm)

4. Cut two side panels③ with a size of 15.7*8.6 inch (40*22cm)

5. Draw the motor part of the frame on side panels③ and saw them off with a band saw

6. Cut two wood strips④ with a size of 15.7*1.9 inch (40*5cm)

Part 2: Making the piano stand under the desk

1. Use a nail gun to nail the wooden strips④ on the left and right sides of the piano frame board

2. Use an oblique hole puncher to punch the side panels③

3. Use an electric drill to bind the side panels③

4. Attach the bound side panels to the table

5. Install one side of the track on the wooden bar of the piano board②

6. After the rail is pulled apart, the mounting hole of the outer rail is exposed

7. Install the other side of the track on the side panel

8. Polish the corners of the table and put wood wax oil on the tabletop

9. Place the assembled table board with the piano stand on the legs of FlexiSpot

10. Assemble the legs and the board with an electric drill

Part 3: Making a desktop computer stand

1. Make 8 holes at an average distance on the table board and the support board①

2. Use an angle grinder to cut 8 support screw rods with a length of 7.8 inches (20cm)

3. Spray the support screw rods with black paint

4. After the paint is dried, the support screw rods are fixed to the top of the table with nuts and washers

5. Fix the support board on the support screw

 

1. Fix the keypad of FlexiSpot

2. The standing desk studio is done!

3. Put on the electronic piano, computer audio and other ornaments needed. Super practical and beautiful!

4. Enjoy your music tour with FlexiSpot!